Would you retain the aspect desk? Hyperlink: https://www.ikea.com/us/en/p/malm-desk-with-pull-out-panel-white-70214192/ #players …
The cleanest funds gaming desk for my part is just not Ikea Alex drawers for the kitchen countertop it is a desk that I utilized in a setup on YouTube and it is the Ikea melon desk nonetheless not the usual desk as a result of the nightfall comes with a aspect desk and does some rails on the underside
To maneuver it nonetheless you may simply select to not set up them in any respect there’s a number of room for cable administration beneath the desk you may simply connect any RGB strips on the again and the perimeters of the desk are robust sufficient to carry a monitor
Arm you could set up by drilling a gap within the desk and that appears extraordinarily clear now an essential warning you can not connect a clamp on the again of the desk so your microphone arm must be linked on the entrance on the aspect however if you happen to can reside with out that then
Used to run this desk. It was pretty good but thr cardboard construction didnt work for my monitor arms, fans etc.
My mum literally has this
Me who uses a USB condenser microphone: I have no such weakness
Ikea utespelare is also very good
I agree
I own a Malm desk as well as two Malm chests of drawers. Clean af
My monitor clamp invalidates this setup
Standing desk or gtfo
can anybody send me a link for this desk?
Bro I think that is my desk
I had this desk.. guaranteed that this desk will sag eventually
I just use a used old herman miller desk that still looks good
I cant hide my laptop there
I have the desk and it's really handy. Good cable management. The most difficult part was installing my monitor arm for my 2 screens (that uses a clamp) but at the end I managed to do so whitout having to drill or cut into the desk
The chances of my triple monitors fitting on that are about 0%
I got a 2m x 1m dining room table lol
bruh my brother has that
rgb is pointless money waste
You can attach things on the back you just need to use a hole saw
I’ve got a malm
I'm at this desk rn hahaha
Btw there is a way to mount monitor arm without drilling a hole , you just need to detached the top and mount the clamp and attached again, it's work fine to me
Be sure on your clamp need to open more then 5cm because the top is quite thicc
I have the desk
ayo i got this lol
What about a second hand office desk. You'll probably get a stronger desk for less
Hold up I’ve had it for like a year great but gets dirty quick
$230 budget desk…
You drilled it but couldn’t cut it to fit your mic clamp?
I got my super clean desk from a proboszcz (a higher level priest we have them in poland idk how it is in other countries) its skeleton frame and dark imitation wood it is a corner desk but its super cool looking and it's easy to add rgb underneath and back you also can attach microphone clamp as i remember in poland it costed like 500pln (like 150 dollars)
You just put a monitor arm on the back and now you can't add a microphone? Fishy. Why not mount it the same way as the monitor arm?
I have it but I have the part that comes out installed and it’s pretty nice to have the extra space
I have that desk
I have atached a clamp on the back by cutting a small piece of the back side of the desk out
He said bujet 💀
I have an old bed frame that has lasted me 9 years and it was from IKEA
Since we are drilling holes in the desk anyway,
why not drill a hole in the desk,
Put a stop in it,
And put the mic arm in there?
That is the one I have without the rails
Ikea desks are so overrated
I have that desk and I hate it its to short
Build your own desk tbh. 120 bucks at Home Depot will get you the lumber, hardware, legs, and finish. A little elbow grease and minimal woodworking knowledge can give you that same "I made this" feeling your custom pc does
i have one like this though it’s the micke
I have this desk too in a corner of my room so the side table look pretty great almost like an L shaped desk + I need that extra space
How much?
I would build a desk, I made a floating desk out of oak, 2700×75 for only 100$ aud and it’s not warped at all built it 6 years ago and it hold heaps of weight and you don’t need much just a saw and some screws and dowels, I haven’t ever done woodwork besides highschool so it’s a great learning project
I have this desk! Served me very well. Plus the pull out side table is handy for extra bits
It will bend as it is not for high weight and so will break tech source shows this
Ikea malm desm
iknew it. dutchie
If u have a rode Mikrofon arm than u can just do it in the table like this monitored
People who agree he is a idiot hit the like
10 likes = education hat
100 likes = genius hat
1000 likes = mega mind hat